The methods behind the boxes on the Butcher’s guide page, explained properly: why they work, step by step, with examples. Pick a method from the list.
These are general guidelines. Every cut, oven and grill is a little different, so check the core temperature with a thermometer and adjust the times. It is also worth double-checking the instructions online.
Your best friend in the kitchen: a meat thermometer
It takes the guesswork out. You know exactly when your steak is rare, medium-rare or medium, and every expensive cut turns out the way you want. A simple instant-read thermometer costs about 15–20 € and pays for itself with the first steak.
Good habits for every cut
Salt early: the day before, or at least 40 minutes before cooking.
Take the meat out of the fridge 30–60 minutes before cooking.
Pat the surface dry: a dry surface browns, a wet one steams.
Take the meat off 2–3 °C before your target. It keeps cooking while it rests.
Always let the meat rest, never skip it: steaks 5–10 minutes, roasts 10–15 minutes before slicing.
Slice across the grain for the most tender bite. With flat cuts like flank and skirt it makes all the difference.
Core temperatures
Rare
50–52 °C
Medium-rare
54–56 °C
Medium
58–60 °C
Medium-well
63–65 °C
Whole cuts of beef are safe to eat pink because the surface is seared. Ground meat is always cooked through: at least 70 °C inside.
Reverse sear
Thick and bone-in steaks: T-bone, ribeye, tomahawk
The reverse sear is the most forgiving way to cook a thick steak. Instead of searing first, you warm the steak gently in a low oven and sear it only at the end. Because the oven is so low, the steak cooks evenly: no grey band under the crust, just pink from edge to edge. It suits steaks of 4 cm or more and bone-in steaks: T-bone, porterhouse, tomahawk, thick ribeye, fillet and the baseball cut of top sirloin.
Salt the steak generously, ideally the day before, and leave it uncovered in the fridge. The surface dries, which gives a better crust.
Take it out 30–60 minutes before cooking.
Put it on a rack over a tray in a 110–120 °C oven. Cook until the core is 8–10 °C below your target: for medium-rare, take it out at about 46 °C.
Heat a cast-iron pan until it smokes, add a little oil and sear about one minute per side. Stand the steak on its edge to render the fat. Add butter, garlic and thyme for the last half minute and spoon it over.
Rest 5–10 minutes and slice.
Example: a 5 cm, 1 kg bone-in ribeye takes about 50–70 minutes in a 120 °C oven to reach 46 °C, then 2–3 minutes in the pan. After 5–10 minutes of rest it is a perfect medium-rare (54–56 °C).
Why rest? Heat keeps moving towards the centre after the meat leaves the heat, so the core still rises a few degrees. Resting also lets the juices settle, so less of them runs onto the board when you cut. Five minutes is enough for a steak, 10–15 minutes for a roast and 30 minutes or more for big barbecue cuts.
Thick steaks and small roasts: fillet medallions, thick picanha steaks
This is the classic restaurant way and gives the same result in a different order: the crust first, then the oven. It is handy when you want to sear everything at once and then cook several pieces in the oven together, for example fillet medallions or thick picanha steaks. Choose the one you like; both work.
Salt early, take the meat out 30–60 minutes before and pat it dry.
Sear in a very hot pan, 1–2 minutes per side, until well browned.
Move the pan (or the meat on a tray) into a 120–150 °C oven. A lower oven is gentler; a higher one is faster.
Take it out when the core is 2–3 °C below your target.
Rest 5–10 minutes. The temperature still rises a little.
Example: a 4 cm fillet steak: 2 minutes per side in the pan, then about 8–12 minutes in a 140 °C oven to 52 °C, and a 5-minute rest for medium-rare.
Why rest? Heat keeps moving towards the centre after the meat leaves the heat, so the core still rises a few degrees. Resting also lets the juices settle, so less of them runs onto the board when you cut. Five minutes is enough for a steak, 10–15 minutes for a roast and 30 minutes or more for big barbecue cuts.
For steaks up to about 3 cm (strip, sirloin, Denver, flat iron, chuck eye) the simplest way is the best: a very hot pan, a short time, and turning often. A thin steak cooks through so fast that an oven would only overcook it.
Pat the steak dry and salt it at least 40 minutes before, or right before cooking.
Heat a cast-iron pan until it smokes. Add a little oil that tolerates heat.
Cook 2–4 minutes per side. Turning every minute or so gives an even crust and an evenly cooked inside.
For the last minute add butter, garlic and thyme and spoon the foaming butter over the steak.
Check the core with a thermometer and rest 5–10 minutes.
Example: a 2.5 cm New York strip: about 3 minutes per side over high heat reaches medium-rare. Do not crowd the pan: two steaks at most in a normal pan, or the pan cools and the meat steams.
Why rest? Heat keeps moving towards the centre after the meat leaves the heat, so the core still rises a few degrees. Resting also lets the juices settle, so less of them runs onto the board when you cut. Five minutes is enough for a steak, 10–15 minutes for a roast and 30 minutes or more for big barbecue cuts.
Flank, skirt, hanger and bavette are full of flavour, and their muscle fibres run in long, clear lines. Cooked quickly and cut the right way, they are tender; cut the wrong way, they are chewy. That is why the knife matters as much as the pan here.
Salt or marinate for at least 30 minutes. These cuts take marinades well.
Cook over very high heat, 2–3 minutes per side, to medium-rare or medium. Do not go further: they toughen.
Rest 5–10 minutes.
Look at the lines of the fibres and cut thin slices across them, at a slight angle. Short fibres mean a tender bite.
Example: a skirt steak for fajitas: 2 minutes per side on a very hot grill or pan, 5–10 minutes of rest, thin slices across the grain, straight into tortillas.
Why rest? Heat keeps moving towards the centre after the meat leaves the heat, so the core still rises a few degrees. Resting also lets the juices settle, so less of them runs onto the board when you cut. Five minutes is enough for a steak, 10–15 minutes for a roast and 30 minutes or more for big barbecue cuts.
Brisket and ribs are made of hard-working muscle and a lot of connective tissue. They need hours at a low temperature, until the connective tissue melts into gelatine. The meat is then juicy and pulls apart. In the oven, wrapped in foil, it is easy and needs no special gear.
Season with salt and coarse black pepper (or your own rub). Brisket goes into the tin fat side up.
Wrap tightly in foil and cook at 140–150 °C.
Brisket takes about 1.5 hours per kg; ribs 2.5–3.5 hours. Start checking early: it is ready when a fork or a probe slides in like into butter, usually at a core of 93–96 °C.
Open the foil for the last 30 minutes so the surface firms up, or brush the ribs with barbecue sauce and give them a few minutes under the grill.
Rest at least 30 minutes, still wrapped. Slice brisket across the grain, about as thick as a pencil.
Examples: a 2.5 kg brisket: about 4 hours at 150 °C; beef back ribs: about 3 hours; a chuck roast for pulled beef: about 4–5 hours, then shred with two forks. If you have a smoker or kamado, the same cuts go there at 110–125 °C with smoke; it takes longer but tastes smokier.
Why rest? Heat keeps moving towards the centre after the meat leaves the heat, so the core still rises a few degrees. Resting also lets the juices settle, so less of them runs onto the board when you cut. Five minutes is enough for a steak, 10–15 minutes for a roast and 30 minutes or more for big barbecue cuts.
Braising means cooking slowly in liquid under a lid. It turns the toughest, most affordable cuts into the softest meat on the plate, and the liquid becomes the sauce. Good for cheek, oxtail, short ribs, shank, osso buco and pot roasts.
Season and brown the meat well on all sides in a heavy pot. The browning gives the sauce its depth.
Add onion, carrot and garlic, then liquid (stock, red wine or dark beer) to about halfway up the meat.
Cover and cook at 150–160 °C in the oven, or gently on the hob, until a fork goes in without resistance.
Let the meat rest in the liquid for 15–30 minutes, then reduce the liquid into a sauce.
Examples: beef cheeks about 3 hours, short ribs about 3 hours, oxtail 3.5–4 hours, osso buco about 2.5 hours. A slow cooker works too: about 8 hours on low after browning. Braises taste even better the next day, so they are perfect to make ahead.
Steaks, picanha, tri-tip, ribs: direct and indirect heat
A grill gives what a pan cannot: smoke, char and the taste of fire. The trick is to make two zones: a hot one (direct heat, right above the coals or burners) for searing, and a cooler one (indirect heat, no fire underneath) where the meat cooks through with the lid closed. With two zones you can grill almost every cut that suits the grill.
Make two zones: on a charcoal grill, pile the coals on one side; on a gas grill, light only some of the burners. Heat with the lid closed for 10–15 minutes.
Brush the grate clean and oil it lightly. Pat the meat dry and salt it.
Thin steaks (under 3 cm), flat cuts and flanken ribs: direct heat with the lid open, 2–4 minutes per side.
Thick steaks, tri-tip and picanha: sear over direct heat, then move them to the cooler side, close the lid and cook to your target core temperature.
Dripping fat makes flames flare up: move the meat to the cooler side for a moment instead of spraying it with water.
Check the core with a thermometer and rest the meat for 5–10 minutes before slicing.
Example: a 4 cm ribeye: about 2 minutes per side over direct heat, then 10–15 minutes on the cooler side with the lid closed (grill about 150–180 °C) until the core reads 52 °C. While it rests it rises to medium-rare.
Why rest? Heat keeps moving towards the centre after the meat leaves the heat, so the core still rises a few degrees. Resting also lets the juices settle, so less of them runs onto the board when you cut. Five minutes is enough for a steak, 10–15 minutes for a roast and 30 minutes or more for big barbecue cuts.